Installation
LS-B10W
29
Excavator Indicate System
P/N: 1022461-01
Bo
d
y
S
ensor
For the TS-i3d dual axis body sensor, locate a convenient surface where the sensor can be mounted
with the label up.
The recommended mounting location is between the boom’s elevation cylinders (Figure 43).
If a secure mounting surface cannot be between the boom’s elevation cylinders, mount the body
sensor to the alternative mounting location on top of the body, or under the boom pivot pin.
Figure 43: Body Sensor Mounting - Top View
L
S
-B10W
The LS-B10W Laser Receiver and bracket must be mounted on the left side of the stick. The following
section describes bracket mounting, cable routing, and LS-B10W Laser Receiver mounting.
1. Before installing the LS-B10W bracket, you must assemble the bracket kit; see the
LS-B10W
Indexing Bracket Assembly Instructions
(p/n: 7030-1370) for more information.
2. Install the LS-B10W onto the bracket.
Boom Pivot
Body Sensor
Body Sensor
Recommended
Location
Alternate
Location
A mark on the laser receiver and the cross hairs on the mounting bracket
are used to determine its position on the stick.
When determining mounting location, be cautious of limitations in cable
lengths.
