Setup Verification
60
Excavator Indicate System
P/N: 1022461-01
S
etup Verification
Performing a full system test verifies the accuracy of the excavator systems at various machine positions.
Testing Machine Element
S
ensors for Accuracy
Testing the sensors on the boom, stick, and bucket requires three bucket measurements at three boom
and stick extensions.
1. Using a hub, record the local coordinates with the following machine positions facing North.
2. Then rotate 180° and record each position again facing South.
Record Bucket Positions with Boom and Stick Fully Extended
It is your responsibility to be completely familiar with the cautions described in
these installation instructions. These messages advise against the use of
specific methods or procedures, which can result in personal injury, damage to
the equipment, or unsafe operating conditions. Remember, most accidents are
caused by failure to observe basic safety precautions.
Bucket extended
Bucket mid-position
Bucket curled
