Topcon RE-S1, Operator'S Manual

Configuration and Usage

RE-S1 Operator’s Manual

8

3. Click 

OK

 to complete the installation (Figure 2-2).

4. If desired, create a shortcut on the computer’s desktop for quick 

access to Modem-TPS (Figure 2-2). 

Figure 2-2. Installation Complete and Shortcut

To uninstall Modem-TPS, use the Start menu on your computer: 

Click 

Start

Programs

Modem-TPS

Uninstall Modem-

TPS

, and click 

Yes

 at the prompt. Then click 

OK

 when the 

uninstall completes.

Configuring the RE-S1 as a 
Repeater

After being configured as a repeater, the RE-S1 will pick up any radio 
signal on the same channel and forward it to another radio modem. 
All modems connected to the repeater must use the same protocol and 
channel.

1. Connect the power cable to the RE-S1 and to a power source.

2. Using the RS-232 serial cable, connect port A of the RE-S1 to a 

computer. 

3. Open Modem-TPS and click Connect.

4. Select the protocol: FH915 Plus.

5. Select your location: United States or Australia.

6. Select the operation mode: Repeater.

7. Select the output power: 1W or 250mW.

NOTICE

The Base, Rover, and Repeater must use the same 
protocol.