Getting Acquainted
P/N 7010-0780
3
• The channel of the RE-S1, Base, and Rover.
• The protocol of the RE-S1, Base, and Rover (FH915 Plus).
Data and Power Ports
The RE-S1 has the following ports:
• Power – used to connect the repeater an an external power source.
• Serial Ports A and C – used for communication between the
repeater and an external device (computer or controller).
Figure 1-3. RE-S1 Ports
Radio Modem Antenna Port and
Antenna
A spread spectrum reverse TNC radio antenna is required to receive/
transmit a radio signal. The antenna connectes to the antenna port on
the end of the RE-S1.
Figure 1-4. RE-S1 Radio Antenna Port
Power Port
Port A
PortC
Radio Modem Antenna Port
Summary of Contents for RE-S1
