11
Preparation for Use
Power Source
Connect the battery according to the type of battery purchased.
For handling batteries, see the "Handling Power Sources" chapter.
Setting Instrument Up
Set the instrument on a tripod or smooth surface.
Power Key
Turn the instrument ON or OFF by pressing the power key.
Automatic leveling will start by turning the power switch ON.
Battery Status Display
Battery status will be displayed for several minutes when the instrument is
powered on or when the battery level changes.
Battery is sufficient. (Stays lit for about one minute)
The power is low, but laser is still usable. (Blinking continues until batteries are dead.)
Dead batteries. Recharge the battery or replace the dry batteries with new ones.(The
laser will turn completely off after blinking for about five minutes.)
NOTE:Even if an AC/DC converter is connected at this time, blinking still continues.
Once the power is turned off, the battery status display will reset.
Note: LS-70A/B Laser Sensor can detect low power state of laser.
Summary of Contents for RL-H3A
