5
6
Reverse polarity of battery clamps is detected.
The Jump Starter is ready for use.
The battery level of the vehicle is too low.
Press the
"BOOST"
Button and wait until
the Safety Indicator becomes solid green.
Then start your vehicle within 30 seconds.
Solid green
Press the Power Button once to turn on the jump starter.
Solid red
Press and hold the Power Button for 3 seconds to turn on the
LED Light. Then press the Power Button once separately to
toggle between Flashlight, Strobe, SOS and OFF in turn.
The battery of the vehicle may be totally dead.
Make sure that you have correctly connected
the clamps to the vehicle battery. Then press
the
"BOOST"
Button and wait until the Safety
Indicator becomes solid green. And then start
your vehicle within 30 seconds.
Flash green
You have tried 4 jump starts within 10
minutes. Please disconnect the clamps
and reconnect to try again.
Alternately flash
red and green
The indicator
doesn't light up
A guide to Safety Indicator:
A guide to LED Light:
Recharge the Jump Starter
Jump Start Vehicles (12V Only)
The product comes partially charged and needs to be fully charged
prior to use. Please charge your jump starter through the Type-C
Input port once you receive it.
Important:
Make sure you have turned off all of the power loads of the vehicle,
including headlights, radio, air conditioner, etc., before attempting to
jump start the vehicle.
Step 1:
Plug the blue end of jumper cable into the Jump Start Socket.
Note: Only jump start vehicles when the battery level of the jump
starter is more than 50%.
EN
