19
2. UPS-01 Power Supply
Before connecting this item, please refer to the chapter of
“Connection of the Power Supply”
.
3. Battery (not included) & Solar panel (Optional, ONLY included in AT6131S/AT12131S)
Please connect them following the chapter of
“Connection of the Power Supply”
.
4. Warning Light (Included in some models, refers to the actual package)
The red wire of the warning light should be inserted into
+LAMP (#15)
terminal, the white wire into the
LAMP-
(#16)
.
5. Photocell Beam System (PBS) (Included in some models, refers to the actual package)
Use a 2-core cable to connect the
“+ ~”
terminal of the photocell’s emitter to the “
+24
”(#1) terminal, the
“- ~”
terminal to the “
GND
”(#3) terminal. Also the
“+ ~”
and
“- ~”
terminals of the photocell’s receiver should be
connected to the “
+24
” and “
GND
” terminals in parallel.
Use another 2-core cable to connect the
“NC”
terminal of the receiver to the “
PHOTO
”(#2) terminal, the
“COM”
terminal to the “
GND
”(#3) terminal.
6. Push Button (optional)
The push button should be wired to the “#4 and “#5” terminals. No matter the polarity. The gate operator works
alternately by pressing the button (open-stop-close-stop-open).
7. Electric Lock (optional)
The electric lock should be wired to the
“+LOCK-”
terminal (“#9 and “#10” terminals), no matter the polarity of
the wires.
8. Exit Wand (optional)
The
BLACK
wire of the exit wand should be connected into the “#5” terminal.
The
BLUE
wire of the exit wand should be connected into the “#6” terminal.
The
RED
wire of the exit wand should be connected into the “#11” terminal.
The
GREEN
wire of the exit wand should be connected into the “#12” terminal.
The sensitivity adjustment board should be wired to the
GREEN
wire and the
YELLOW
wire of the wand. No
matter the polarity.
9. Wired Keypad (24VDC) (optional)
The
RED
wire of the wired keypad should be connected into the “#11” terminal.
The
BLACK
wire of the wired keypad should be connected into the “#5” terminal.
The
PURPLE
wire of the wired keypad should be connected into the “#5” terminal.
The
BLUE
wire of the wired keypad should be connected into the “#4” terminal.
10. External receiver (optional)
The
RED
wire of the external receiver should be connected into the “#11” terminal.
The
BLACK
wire of the external receiver should be connected into the “#5” terminal.
The
BROWN
wire of the external receiver should be connected into the “#4” terminal.
