13
1. Motor
The
YELLOW
wire of the motor should be connected into the
“
1
”
terminal.
The
RED
wire of the motor should be connected into the
“
2
”
terminal.
2. Limit Switches
The
YELLOW
wire of the limit switches should be connected into the
“
3
”
terminal.
The
BLACK
wire of the limit switches should be connected into the
“
4
”
terminal.
The
RED
wire of the limit switches should be connected into the
“
5
”
terminal.
3. Warning Light (Included in some models, refers to the actual package)
The
WHITE
wire of the warning light should be connected into the
“
6
”
terminal.
The
RED
wire of the warning light should be connected into the
“
7
”
terminal.
4. Photocell Beam System (PBS) (Included in some models, refers to the actual package)
Use a 2-core cable to connect the
“
- ~
”
terminal of the photocell
’
s emitter to the
“
19
”
terminal, the
“
+ ~
”
terminal to the
“
18
”
terminal. Also the
“
- ~
”
and
“
+ ~
”
terminals of the photocell
’
s receiver should be
connected to the
“
19
”
and
“
18
”
terminals in parallel.
Use another 2-core cable to connect the
“
NC
”
terminal of the receiver to the
“
13
”
terminal, the
“
COM
”
terminal to the
“
12
”
terminal.
5. Push Button (optional)
The push button should be wired to the
“
16 and
“
17
”
terminals. No matter the polarity. The gate operator
works alternately by pressing the button (open-stop-close-stop-open).
6. Exit Wand (optional)
The
BLACK
wire of the exit wand should be connected into the
“
14
”
terminal.
The
BLUE
wire of the exit wand should be connected into the
“
15
”
terminal.
The
RED
wire of the exit wand should be connected into the
“
18
”
terminal.
The
GREEN
wire of the exit wand should be connected into the
“
19
”
terminal.
The sensitivity adjustment board should be wired to the
GREEN
wire and the
YELLOW
wire of the wand. No
matter the polarity.
