17
How to Use the Remote to Operate Your Gate Opener
Each remote has four buttons, from top to bottom are separately A, B, C and D. You
may use this remote to operate as many as 4 sets TOPENS swing gate openers or 1
set TOPENS sliding gate opener and 2 sets TOPENS swing gate openers.
1. Use this remote to only operate TOPENS swing gate opener A, B, C and D four
buttons share same function once they are programmed with
TOPENS swing gate opener. You may choose any button to program it with our swing
gate opener. Every press of the button is able to active the gate opener to work
alternately (open-stop-close-stop-open).
2. Use one remote to operate TOPENS swing gate opener & sliding gate opener at
the same time
All of TOPENS sliding gate opener have midway mode. Button B is designed to realize midway function (refer
to more details in our TOPENS sliding gate opener manual). So it is must program button A with sliding gate
opener, while you may program either C button or D button with TOPENS swing gate opener.
Wireless Keypad Programming
You can follow the below steps to program wireless keypad to the opener. Press the
Learn
button until the
REM
LED is ON
,
and then releases the button. Then press "OK" button on keypad and
REM
LED will flash
for 3 seconds and then be OFF which indicates the keypad has been programmed successfully. You can use
the default password
“
888888
”
to operate the opener after programming. You can press
“
PIN
”
“
8 8 8 8 8 8
”
and then press
“
OK
”
to confirm to operate the opener.
Also you can change the password of the keypad follow the below steps. Press
“
PIN
”
and then input the six
digits old password and then press
”
PIN
”
again, the
REM
LED will be ON. Input the six digits new password
and then press the
“
PIN
”
to confirm the new setting,
REM
LED will flash for 3 seconds and then be OFF
which indicates the password has been changed successfully. You can press
“
PIN
”
“
6 digits new password
”
and then press
“
OK
”
to confirm to operate the opener.
NOTE:
Every step for pressing button during program must be finished within 1 second to ensure successful
programming.
