17
Exit Wand (optional)
Please note that the adapter board of the exit wand should be inserted into the main control board of
the gate opener before using.
The
BLACK
and the
BLUE
wire of the exit wand should be connected into
the “LOOP” terminal, no matter the
polarity.
The
RED
wire of the exit wand should be connected into the COM (9#) terminal.
The
GREEN
wire of the exit wand should be connected into the BAT- (14#) terminal.
The sensitivity adjustment board should be wired to the
GREEN
wire and the
YELLOW
wire of the wand. No
matter the polarity.
Electric Lock
(optional)
The electric lock should be wired to the
―LOCK‖
terminal, no matter the polarity of the wires. The E-Plus board
is not needed to use with this model of gate opener. Please remove the board from the lock before using.
External Receiver (optional)
The
BROWN
wire of the external receiver should be connected into the “19” terminal.
The
BLACK
wire of the external receiver should be connected into the “20” terminal.
The
RED
wire of the external receiver should be connected into the “9” terminal.
Wired Keypad (24VDC) (optional)
The
RED
wire of the wired keypad should be connected
into the “9” terminal.
The
BLACK
wire of the wired keypad should be connected into the “14” terminal.
The
PURPLE
wire of the wired keypad should be connected into the “19” terminal.
The
BLUE
wire of the wired keypad should be connected into the “20” terminal.
How to Program or Erase the Remote
The remote MUST be programed to the opener BEFORE OPERATING. Please follow the steps to
program the remote.
Activate the opener only when gate is in full view, free of obstruction and properly adjusted. No one
should enter or leave gate area while gate is in motion. DO NOT ALLOW CHILDREN to operate push
button or remote. DO NOT ALLOW CHILDREN TO PLAY NEAR THE GATE.
If you purchase additional remote controls, the gate opener must be programmed to accept the new
remote code.
If you lose one of any remote control, please erase and reprogram all other remote controls to have a
new code for safety.
Program the remote
Press and release the learn button, the
LED
will display
―Ln‖,
then press the key on the remote
two times
in 2
seconds,
between the two times HOLD ON FOR A MOMENT
, the
LED
will flash
―Ln‖
for 4 seconds then
Summary of Contents for KD902
