9
6
. Sign the bolt-hole point on the gate post and gate. Do this by placing
a punch or a sign in the middle of each bolt slot on the post bracket
assemblies and the gate bracket. It allows slight adjustments to the
post bracket. Then remove the post bracket and gate bracket by taking
off the C-clamps.
7.
Drill 14mm diameter holes on the gate post and drill 9mm diameter
holes on the gate at the marked locations.
8.
Attach the post bracket assemblies to the gate posts by using four
expansion bolts.
9.
Attach the gate brackets to each gate by inserting two M8x80 bolts
through the gate brackets and the drilled holes in the gates. Fasten
each bolt with one
￠
8 lock washer, and one
￠
8 nut.
10.
With the opener fully retracted and with the gate in the fully open
position (for Pull-to-Open installation), attach the gate opener to the
Post Bracket Assembly and the Gate Bracket by inserting a thread pin
through the gate opener and the Pull to Open Bracket and another
thread pin through the gate opener and the Gate Bracket.
Summary of Contents for MT9012
