7
Preparation for Installation
There are two installation types for the gate opener,
Pull-to-Open
and
Push-to-Open.
In the
Push-to-Open
installation, gate opens out from the property. A
Push-To-Open
Bracket is required to be
used for each gate.
The gate opener can be either installed on square gate post or
rounded gate post.
when the gate post is square, the width of the gate post should
be at least 120 mm.
When the gate post is rounded, connect post bracket to the
gate post via pipe clamps, requires the diameter of the gate
post should be less than or equal to 80mm.
Install the Opener on the Gate –
for Pull to Open
The position of Post Bracket is very important. The following illustrations and tables are required to determine
the proper mounting position for the Post Bracket. The tables show the maximum opening angle of the gate for
a given A and B. For example, if A is 18cm and B is 16cm, the maximum opening angle of the gate is 104°
Pull-to-Open Installation — Gate in Closed position (Moving-Rod is extended)
NOTE:
Ensure the gate does not open into public areas. One more person will help when installing.
Summary of Contents for MT9012
