14
Sectional and One-Piece Door Installation Procedure:
Door bracket has left and right side fastening holes. If your installation requires top and bottom fastening
holes use both the door bracket and door bracket plate as shown.
Center door bracket (with or without door bracket plate, as required) at the top inside face of door as shown.
Mark holes.
3.7Assemble Door Arm (NOT Bow Arm)
A. ONE-PIECE DOOR INSTALLATION:
Fasten the straight (1) and curved (2) door arm sections together to the longest possible length (with a 2 or 3
hole overlap) using hardware (3, 4 and 5). With the door closed connect the straight door arm section (1) to
the door bracket with clevis pin (6). Secure with “R” pin (7). Disconnect the inner and outer trolley. Slide the
outer trolley back toward the opener and join the curved arm (2) to the connector hole in the trolley (8) with
clevis pin (6). It may be necessary to lift the door slightly to make the connection. Secure with “R” pin (7).
NOTE:
When setting the up limit, the door should not have a “backward” slant when fully open. A slight backward slant
(9) will cause unnecessary bucking and/or jerking operation as the door is being opened or closed from the fully open
position.
B. SECTIONAL DOOR INSTALLATION:
Connect according to Figure B, and then proceed to Step A.
Summary of Contents for MultiRuta CASAR 800
