multiSwitch – user manual
© TOPEX 2008 130
8.12 The "Templates" menu
The "Templates" menu contains a series of templates (patterns) that can be applied to clients
and client classes to facilitate the adding and registration in the database of the TOPEX multiSwitch
equipment.
The "Templates" menu contains the following options:
Class Templates
– template for client classes
SIP User Templates
– template for SIP users
FXS User Templates
– template for FXS users
ANI User Templates
– template for ANI users
Prepaid User Templates
– template for Prepaid users
Figure 105 – The "Templates" menu
8.12.1 The "Class Templates" option
The "Class Templates" option contains templates for the client classes to be added in the
database of the TOPEX multiSwitch equipment.
You can create a template for a client class, and when adding a client class from the "Server
Management" menu, you can use the "New Class from Template" option, which will simplify your work.
This option is recommended when massive data volumes must be entered in the system.
The fields that have to be filled in are similar to the ones in the "Client Classes" menu.
Billing Group
– associate the client class with a previously defined billing group
Name
– name of the client class to be created
Type
– select the
Class
option to create a client class. The other available option is "
Port
".
Trunk
– If this option is checked, the client class will be displayed as a route for "Destination Class"
(the Reseller can select that client class as route to "Destination Class");
Billing Profile
– the billing profile used for that client class. Billing profiles are created in the
Billing –
Profiles
section;
Search Mode
– used for routing when same prefix routes are used. The available options are:
-
Up
– The route will be selected starting from the last to the first. Depending on its position in the
routing table, the last route in the group will have the highest priority.
-
Down
– The route will be selected starting from the first route to the last. Depending on its position
in the routing table, the first route in the group will have the highest priority.
-
Circular
- The route will be selected circularly.
RTP Proxy In / Out –
represents an application that runs on the TOPEX multiSwitch equipment and
transfers UPD packets from one port to another. RTP Proxy is used for transferring the RTP voice
packets behind the NAT. For each call, two UDP ports are opened. The application directs the UPD
packets received on one port to another port. Here, you can select one of the following options: "
Not
Used
", "
Used except users in the same NAT
" or "
Always Used
";
