26
Service Search
You should set the
Search Mode
option to
Auto
at the first ser-
vice search after installing the digital receiver. The digital re-
ceiver will search all available services with automatic search
mode. Transponder numbers range from 6 to 12 at VHF and
28 to 69 at UHF.
To search a certain transponder, set the
Search Mode
option
to
Manual
, and select your desired transponder at the
Channel
parameter.
To search one service of a transponder, set the
Search Mode
option to
Advanced
, and specify the PIDs of your desired ser-
vice at the
PID
menu with the numeral buttons. PID (Packet
Identifier) is a set of numbers that identifies transport stream
packets.
To start service search, select the
Service Search
command.
Then appears a list box, in which found services will be listed.
Press the
¤
£
¡
¢
OK
button to save found services when service search
has been completed. To stop service search on the way or exit
without saving, press the
¤
£
¡
¢
EXIT
button.
4.2
Resetting to factory settings
The digital receiver maintains the following data:
•
Service list
•
Favorite list
•
Timer events
•
Preference settings
You can reset all data of the digital receiver. To reset all the
data, select the
Installation
>
Factory Setting
menu. Then a
confirmation box appears. With the
Yes
reply, service entries,
favorite entries and timer events will be all deleted, and pref-
erence parameters will be reset to the manufacturer’s factory
settings.
