2.4 Connecting up your digital receiver
15
To use the RF connector
If your television does not have any video and audio input,
you will need to use the radio frequency output from the dig-
ital receiver.
In this case, you will need to connect a ca-
ble from the
RF OUT
socket to the antenna
connector on your television. To ensure your
television can also pick up existing analogue
channels as well, you will need to connect
a cable from
RF LOOP 2 OUT
connector on
the back of the digital receiver to the
RF IN
connector.
Tune your television to channel 36 so that you can see the out-
put from the digital receiver.
2.4.3
Connecting to your video cassette recorder
The digital receiver can also output video to another appliance
such as a video cassette recorder or video receiver through an
auxiliary SCART connector.
You will need to obtain a SCART cable to
use the auxiliary SCART connector. Plug
one end of the cable into the
VCR
socket on
the digital receiver, and the other end into
the matching socket on your video cassette
recorder or suchlike.
2.4.4
Inserting batteries in the remote control
To insert the batteries, open the battery compartment by re-
moving the lid, and then insert the batteries observing the po-
larity, which is marked on the base of the battery compart-
ment.
If the digital receiver no longer reacts properly to remote con-
trol commands, the batteries may be flat. Be sure to remove
Summary of Contents for TF 5000 PVRt
