28
Service Search
Manual search
You may choose to search only services of a specific trans-
ponder because more than one service are provided via each
transponder. To do that, set the
Search Mode
option to
Man-
ual
, and then at the
Channel
option select your desired trans-
ponder. The number ranges from 6 to 12 in VHF and 28 to 69
in UHF.
To search one service of a transponder, set the
Search Mode
option to
Advanced
, and at the
PID
option specify the PIDs of
your desired service with the numeric buttons. PID (Packet
Identifier) is a set of numbers that identifies transport stream
packets.
Start search
To start service search, select the
Start Search
item; then a list
box appears, in which found services will be listed. When it
has completed, press the
OK
button to save found services.
To stop at any time, or to exit without saving, press the
EXIT
button.
4.2
Resetting to factory settings
You can reset all data of the digital receiver. If you want to re-
set all the data, select the
Installation
>
Factory Setting
menu,
then you will be asked for confirmation. If you select
Yes
,
service entries, favourite entries and timer events will all be
deleted, and preference options will be reset to the manufac-
turer’s factory settings.
NOTE
Doing a factory reset will not delete any recorded items on the
hard disk drive.
Summary of Contents for TF 5000 PVRt
