MENU OPERATIONS
31
LNB Setting
The Low Noise Block down Converter (LNB) amplifies the signal received by the
satellite dish and lowers the frequency of the signal. The signal is then fed from the LNB
at the dish via cable to the PVR.
For the LNB Setting, move the cursor to
Installation
item and press
OK
button.
Then, move the cursor to the
LNB Setting
item and press
OK
button.
A. Satellite Name
Press
OK
button to display the Satellite List. The list of Satellite is put in alphabetical
order. Select one of the preprogrammed satellites that corresponds to the direction of
the antenna. If the desired satellite name is not in the list, then select
Other
.
B. Tuner Select
Select a tuner for channel searching from the selected satellite.
C. Connection Type
If two tuners share one LNB, select
Loop Through
. If a service is being recoded, the
other tuner can receive only the signal of the same band and polarity as being recorded
in this configuration.
If the tuners are connected to separated LNBs (or Dual LNB), select
Separated
. There
is no restriction as in the
Loop Through
configuration.
D. LNB Frequency
Select the L.O. Frequency of the LNB. The LNB Frequency of 5150, 9750, 10600,
10750, 11475, 9750/10600 or 9750/10700 can be selected by
V-
or
V+
button.
Also you can insert LNB frequency by using Numeric key on the RCU
.
E. LNB Power
Select LNB power
On
to output the LNB voltage.
F. 22 KHz
If you are using a 22 KHz tone switch box, make 22 KHz tone switch enable or disable
to select LNB or antenna.
