18
Service Search
You should set the
Search Mode
option to
Auto
for the first
time after connecting up the digital receiver, then the digital
receiver will search for all available services.
You may choose to only search for the services of a specific
transponder since more than one service are provided via each
transponder. Set the
Search Mode
option to
Manual
, then se-
lect your desired transponder at the
Channel
option. The num-
ber ranges from 6 to 12 in VHF and 28 to 69 in UHF.
It is possible to search single service in a certain transponder
only if you know the desired service’s audio and video packet
identification (PID). Set the
Search Mode
option to
Advanced
,
then the
PID
option becomes enabled. Specify the PIDs of your
desired service with the numeric buttons.
To start service search, move down to the
Start Search
item,
and press the
OK
button. The digital receiver will start to
search for services and display a list of television and radio
services as they are found. It is common for no channels to be
found until quite late in the process. When the scan is com-
plete, you will see a message telling you how many services
have been found. Press the
OK
button to save the list.
3.2
Resetting to factory settings
The digital receiver maintains the following data:
• Services list
• Favourite list
• Timer list
• Preference settings
You can reset all data of the digital receiver. Select the
Instal-
lation
>
System Recovery
>
Factory Setting
menu, and then
you get asked for confirmation. With the choice of
Yes
, the
services list, favourite list and timer list will all be cleared, and
preference options will be reset to the manufacturer’s factory
settings.
