GTalarm3 User manual V-2022-05-24
40 |
E N
4.5
Zones programming
Detection devices such as motion detectors and door contacts could be
connected to the module’s zone terminals. Once connected, the associated
zone’s parameters must be configured.
GTalarm3 comes equipped with 4 on-board wired zones and 2 programmable I/O inputs. For additional detection device connection, the number
of zones can be expanded. GTalarm3 zones can be expanded with expansion module up to 32.
Zone bypassing allows the user to deactivate a violated zone and arm the system without restoring the zone. If a bypassed zone is violated or
restored during exit/entry delay, or when then system is armed, it will be ignored.
Stay mode allows the user to arm and disarm the alarm system without leaving the secured area. If the zones with Stay attribute enabled are
violated when the system is STAY-armed, no alarm will be caused. Typically, this feature is used when arming the system at home before going to bed.
