GTalarm3 User manual V-2022-05-24
49 |
E N
4.9.1
Reporting to the user‘s mobile phone
GSM Communications > SMS DIAL Reporting
The
SMS DIAL Reporting settings let you enter user’s phone numbers and set
events that will be reported to the user
When a zone or tamper is violated, depending on zone, the system will cause an alarm. During the alarm, the system will follow this pattern:
1. The system activates the siren/bell. The siren/bell will emit pulsating sound if the violated zone is of Fire type, otherwise the sound will be steady.
2. The system attempts to send an SMS text message (if programmed), containing the violated name. The system will send SMS text messages regarding
each violated zone separately.
a) If the user phone number is unavailable, it will attempt to send the SMS text message to the next listed user phone number, assigned to the same zone
as the previous one. The user phone number may be unavailable due to the following reasons: mobile phone was switched off or was out of GSM signal
coverage.
b) By default, the system will continue sending the SMS text message to the next listed user phone numbers in the priority order. The system try to send
the SMS text message as many times as programmed.
3. If programmed, the system attempts to ring the first user phone number via GSM. The system will dial regarding each violated zone separately.
The system will dial the next listed user phone number, assigned to the same zone. The user can be unavailable due to the following reasons:
Mobile phone was switched off, mobile phone was out of GSM signal coverage or provided “busy” signal.
d) The system will continue dialing the next listed user phone numbers in the priority order. The system will dial again as many times as programmed and
the same order as phone numbers listed in the memory if it end up with all unsuccessful attempts to dial to the user.
The module could be controlled and monitored only by these users, whose phone numbers entered in the memory of the module
SMS Notifications to USER:
SMS reporting to selected index of telephone number is enabled.
Auto DIAL to USER:
Auto DIAL to selected index of telephone number is enabled. e.g. Call to Tel1 in case of Input/Zone1 Alarm/ Restore
Tel1... Tel8:
SMS messages will be send and calls will be made to these phone numbers in case of these alarm events. User numbers should be
entered with international code. ([country code][area code][local number]) Without symbol '+'. E.g. the mobile number of user in United Kingdom is +44
(0) 113 xxx xxxx, so Correctly entered user number: 44113xxxxxxx
Limit of alarm dialing:
Indicate maximum number of unsuccessful calls
SMS forwarding to Tel.1
SMS from the module resending to the other phone number
Show Object Name:
Object name will be displayed in the SMS message
Show Zone Number:
Zone number will be displayed in the SMS message
Show Event Time:
Event time will be displayed in the SMS message
Show CID Code:
Report Contact ID code
4.9.2
Custom SMS Text
