Walk-Behind String Trimmer Mower
12
GB
1. The engine must be off and allowed to cool
at least three minutes before adding fuel.
2. Remove the fuel filler cap and fill the tank.
(See engine manual for fuel capacity, fuel
recommendation, and location of fuel cap.)
3. Reinstall the fuel cap and tighten. Always
clean up spilled fuel.
IMPORTANT: DO NOT OVERFILL!
This equipment and/or its engine
may include evaporative emissions
c o n t r o l s y s t e m c o m p o n e n t s ,
r e q u i r e d t o m e e t E P A a n d /
or CARB regulations, that will
only function properly when the
fuel tank has been filled to the
recommended level. Overfilling
may cause permanent damage
to evaporative emissions control
system components. Filling to
the recommended level ensures
a vapor gap required to allow for
fuel expansion. Pay close attention
while filling the fuel tank to ensure
that the recommended fuel level
inside the tank is not exceeded. Use
a portable gasoline container with
an appropriately sized dispensing
spout when filling the tank. Do not
use a funnel or other device that
obstructs the view of the tank filling
process.
Fill the fuel tank outdoors, never
indoors. Gasoline vapors can ignite
if they collect inside an enclosure.
Explosion can result.
ADJUSTING TRIMMER HEIGHT
The height of cut can be set to five different
positions ranging from 1.5 inches to 3.5 inches.
Higher positions are useful when trimming
tall grass or in conditions where frequent
objects (rocks, small limbs) are on the ground.
Lower positions will provide a more finished
appearance. Recommended cutting height for
the average yard is 2 inches.
1.
To adjust the trimming height, push the
trimmer head height locking plate tabs on
each side of the trimmer head and move
trimmer head up or down to desired
position. If the head will not disengage,
slightly rotate the head while pushing the
locking plate tabs.
2. Release the tabs and be sure the trimmer
head is locked into one of the 5 height
positions.
2
1
