- 8 -
Ensure that cut off tile pieces are not caught by the blade and sent flying.
Never remove loose splinters, Chips pieces while the diamond blade is moving.
Before repairing faults or removing jammed tile, always switch the cutter off and pull out the mains
plug.
If the cutter slot has been knocked out of position, replace the bench liner. Pull out the mains plug
first.
Before switching on, check that all spanners and setting tools have been removed.
When leaving the workplace, switch off the motor and pull out the plug.
After carrying out repair or maintenance work all safety and security fixtures must be replaced
immediately.
The manufacturer’s safety, working and maintenance instructions and the dimensions stated in the
Technical Information must be adhered to.
The relevant regulations for the prevention of accidents and other generally recognized safety
regulations must be followed.
Observe the code of practice drawn up by the trade association .
Operation of the cutter in confined spaces is permissible only if a suitable suction extraction system
is used.
Caution! Switch off cutter immediately and pull out plug if
-
the power feed lead and switch are damaged
-
the motor is overheating
-
smoke is emitted or there is a smell of charred insulating material.
Use only diamond blade for which the maximum possible speed is not less than the maximum
spindle speed of the cutter and the material to be cut;
When transporting the machine, use only transportation devices and do never use guards for
handling or transportation;
Fill the cooling tank 3/4 full of water. It is quite normal for the equipment to cause spluttering during
use.
Pay attention to the width of the work piece. Please refer to Fig.1, if the marked width on “
a
” is more
than 315 mm, please pull out the extension table to support the work piece.
Fig.1
IV SPECIAL SAFETY INSTRUCTIONS BEFORE USING THE MACHINE
●
Check the following points:
1.
Does the voltage of the motor correspond to the mains voltage?
a
