- 9 -
2.
A grounded mains connection (wall socket) needs to be used.
3.
Are the mains lead and the mains plug in a good condition without any loose ends or damage.
●
Avoid using long extension cables.
●
Always place the cutting machine on a flat surface to prevent instability.
●
While using the machine
1. Never use-cracked diamond blade, replace them.
2. Be sure that the switch is in the OFF-position before connecting the machine to the mains voltage.
3. Always keep away the mains lead from moving parts of the machine.
4. Do not apply side-pressure to the diamond blade. It can break the blade and cause the danger.
5. Remove the plug out of the wall socket before you open the machine.
Warning: before any operation with this machine, make sure sufficient local lighting has been
provided.
●
IMMEDIATELY SWITCH OFF THE MACHINE IN CASE OF:
1.
Malfunction of the mains plug, socket or damaged cables.
2.
Broken switch.
3.
Smoke or smell caused by scorched insulation.
V INSTALLATION AND OPERATING
A.STARTING AND STOPPING THE SAW
Insert the plug into a socket with a safety contact. This must
be protected with a fuse e.g. in the terminal box. If an extension cable is required, please note that with
a cable length of up to 20 m cable with a cross-section of 1.5 mm² must be used.
To start the saw, press the green button marked “
I
”.
To stop the saw, press the red button “
O
”. (Fig.1)
WARNING:
For your own safety, always push the Switch “
O
” position
when the tool is not in use...in the event of a power failure (all of your
lights go out) or blown fuse or tripped circuit breaker, turn switch “
O
”
position and remove the key. This will prevent the tool from starting up
again when the power comes back on.
Overload Protection: the motor is equipped with Circuit Breaker.
If the motor is over loaded, gets too hot or the current gets very big,
the circuit breaker will act automatically. If this occurs, please wait a
few minutes until the motor has cooled down and then press
the reset button (beside the On-/Off-Switch) and the cutter can restart.
Note: Residual Circuit Device (RCD) is strongly recommended be installed for your own safety.
B. ASSEMBLY
Read the manual carefully before installation
1.
Clean
the working area, open the package and remove all packing materials,
you will find the
folded machine. (Fig.3)
2.
Lay
the stand on level surface, stand it up according to procedures as shown in Fig.4 to Fig.8.
3.
To
stabilize stands by adjusting the leveling “set screw” located on the bottom of right front stand.
Fig.2
