11
2
、
Remove the screw and washer and open the frame cover
3
、
Remove the screw and washer (A), Remove the rear blade guard.
4
、
Remove the screw (B), Remove the front blade guard.
5
、
Loosen the blade tension knob and remove the old blade from the wheels.
6
、
Insert the new blade in middle of the guide bearings and assemble the blade on two wheels.
7
、
Tension the blade by adjusting the blade tension knob.
8
、
Replace the font blade guard, rear blade guard and frame cover.
Machine care
Usually check the condition of the power supply cords and replace them if they are broken, or even
worse if the internal wires are shown.
Use a brush and a shop vacuum to remove chips and other debris from the machine.
Always keep the machine handgrip clean to prevent accidental slipping during use.
Remove the processing residues from the cutting area and the blade guides whenever necessary.
If you do not intend to use the sawing machine for a long time, clean it and put it in a dry place if
possible. In these cases it is advisable to slacken off the blade so that it is not kept for any reason.
To ensure effective machine operation, check the condition of the blade daily and sharpen it
whenever necessary.
A
Frame cover
Rear blade guard
Front blade
guard
B
Blade
Blade tension
knob
Summary of Contents for GFW 5012-2
Page 13: ...13 ASSEMBLY DIAGRAM...
