Sprayer Type
Pump Type Max. Pump Press. Rated Voltage
Motor Power
On-Vehicle
diaphragm
pump
9bar
12VDC
65W
Tank Capacity
Length of Power cord
Length of Outlet
Hose
Length of Bundling
Belt
60L
100L
5M
5M
5M
spray gun
spray
Press
5.5bar
Flow
2.1L/min
stream
Press
3.5bar
Flow
3.1L/min
level range
8m
Spray
Lance
Press.
4.5bar
Flow
2.6L/min
3.
How to Operate the Sprayer
i. Mount the Sprayer
1. For initial use, please check the components in the package upon
unpacking to make sure all that on the packing list are included before
proceeding to mount as instructed in the Diagram. (Refer to Explosive view for
serial number and description)
2. Place the tank on the assembled chassis and fastened with
5/16-18X16
screws and bundling belt ;
3.Assemble the spray lance in series and fasten with the nut. Connect the
lance to hose through a T-shaped Tee.
4. Press the assembled spray lance into the groove of clamp on the beam.
Adjust the spray angle to a preferred position so that the four nozzles shall be
on the same plane, and outward inclined for a certain angle. Meanwhile the
spray fan area shall have an angle of 5-10 degrees with the spray lance to
prevent against spraying to the vehicle chassis and maximize the chemical
spray onto the crops ;
6 The spray lance shall be installed to be parallel to the ground with a
proper height. Insufficient height likely causes missing due to terrain impact;
Excessive height may lead to uniform distribution due to influence of wind.
The preferred height of nozzle in case of spraying
herbicide or soil
treatment
is 50 cm. The preferred height of nozzle in case of spraying
insecticides, fungicides and growth regulators
is 30 cm.
ii. Operating Instructions
* You’d better carry out spraying job of pesticides in the morning or
afternoon of a cool, windless day , so as to reduce volatilization and drifting
of pesticides.
* For initial use, please make a trial spray with water , check the
diaphragm pump for possible fault and make sure the joints are free of
leakage.
1.
Close the two shut-off valves. Fill the tank with prepared
chemical solution through a large strainer, and then tighten the tank lid;
2.
Start the motor. Arrange the whole unit according to the scheduled
route. An extra-large spraying area should be divided into a number of plots,
and the routes shall be determined according to the wind direction. Generally,
the sprayer advancing direction shall be wholly or partially perpendicular to
