the wind direction.
3.
Insert the output end of the power cord into the input end of
diaphragm pump, and connect the two wire clamps on the input end of the
power cord to the positive and negative output terminals of the battery or the
output end of vehicle’s magneto (red line is positive, black is negative)
respectively . Now the diaphragm pump starts working;
4.
Start up the engine to move forward in accordance with the
predetermined route, while opening the shut-off valve of the gun or the lance to
start spraying.
iii. Precautions
1.
Prohibit the use of some special chemical
2.
Handling of agriculture chemicals should comply with the safety
instructions provided by the manufacturer.
3.
Check the terrain, slope, ground roughness, crop growth and make
sure no obstacle in the operation area before the sprayer moves forward..
4.
In case of level spraying with spray lances, the sprayer shall move
forward at a rate of no more than 8km / h.
5.
The spray fan angle shall be complete, unbranched, and free of
dripping. Try to maintain a uniform flow and steady spray.
6.
Diaphragm pump comes with a pressure protection switch and allows
for short-term non-water running. However, when the pump is intended to be
put idle for a long time, or in the process of water-filling, you’d better
disconnect the power cord to avoid undesired battery power consumption and
prolong pump life.
iv. Cleaning and warehousing
After operation, the sprayer should be cleaned at an allowed place.
Cleaning method: Fill the sprayer with fresh water and start the diaphragm
pump to spray out; For external surfaces, clean with a damp cloth.
Note: The diaphragm pump shall never be immersed in water for
cleaning .
The cleaned machine should be placed in a dry, ventilated room, out of
the reach of children. The spray lance may be disassembled for separate
cleaning and kept in a box after drying.
IV. Explosive View and Detailed List
