29- PEAK/MUTE LED
This LED lights up when the input signal is too strong or in case of the digital effect module being muted.
30- MUTE SWITCH
This switch is used to activate/deactivate the effect facility.
REAR PANEL
31- AC INPUT
This connector is used to connect the supplied AC Adapter.
32- POWER SWITCH
This switch is used to turn the main power ON and OFF.
1- Speakers should be placed in a position that allows for unobstructed sound projection. In
many instances is beneficial for speakers to be elevated on tripod stands to achieve maximum
dispersion and reach.
2- Use professional advice or service when hanging and installing speakers. Please take
precautions to secure them to prevent them from falling and hurting someone. Care should be
taken as to not damage the cabinet or its components. Please comply with all pertinent
Regulations.
3- Use quality cables. Using quality cables will ensure the best possible sound.
4- For best results match the speakers to a good amplifier that matches the wattage and
impedance of your speakers. Proper amplification power results in good quality audio and
longer component life. Check out the power requirement for your cabinet.
5- Avoid pointing a microphone directly at an amplified speaker doing so, could cause feedback
possibly damaging speaker components and your hearing.
Installation Tips
Enjoy the sound!
Summary of Contents for MXI Series
