I dip-switch sono 10 micro interruttori presenti sulla scheda e accessibili aprendo il coperchio della scheda di controllo
(Figura 20).
Ciascun dip-switch (Figura 26 riferimento "C") può essere impostato in 2 posizioni contraddistinte dagli stati ON e OFF. Al
primo utilizzo tutti i dip-switch sono impostati in posizione OFF tranne i dip 7-9-10 che sono impostati in ON.
Di seguito vengono riportate le funzioni dei singoli dip-switch:
-DIP-SWITCH N°10:
Se portato in posizione di
ON,
in caso di mancanza di tensione di alimentazione, al ripristino la porta
esegue automaticamente la procedura di reset.
-DIP-SWITCH N°9
:Il dipswitch 9, se portato in posizione
O
N, fa chiudere la porta a velocità molto lenta, a prescindere dal
peso porta impostato sul selettore "A".
-DIP-SWITCH N°8
:Se portato in posizione di
ON
, permette un arresto graduale della porta in apertura (soft stop).Tale
funzione è stata creata per porte di peso relativamente basso; nel caso in cui la porta abbia un peso medio/alto,può
verificarsi la possibilità che la porta non completi il ciclo di apertura, quindi sarà opportuno riportarlo in posizione di
OFF
.
-DIP-SWITCH N°7:
Permette di selezionare la porta come principale o secondaria in caso di funzionamento in tandem
(due attuatori collegati).Se portato in posizione di
ON,
la porta ha un funzionamento principale (da utilizzare per porte
singole o porte che gestiscono altre porte),se settato in
OFF
la porta ha un funzionamento secondario (vengono
disabilitati tutti i comandi e il funzionamento è garantito solo da comandi forniti dalla porta principale collegata) e attende
comandi da una porta principale.
-DIP-SWITCH N°6-5-4-3-2-1
:Permette il settaggio indirizzo porta. Nel caso in cui la porta sia singola, tutti i dip-switch
devono essere settati in
OFF
. Nel caso in cui il funzionamento sia in tandem, il settaggio dei dip-switch deve essere
identico per entrambe le porte.
4.4
PROGRAMMAZIONE DEI DIP-SWITCH
Tasto 1-2
Tasto 3-4
Tasto 5-6
Tasto 7-8
Utilizzare il telecomando solamente con la porta totalmente in vista.
13
IT
ISTRUZIONI PER L’INSTALLAZIONE E L’USO
M1
Summary of Contents for M1
