Contattare servizio assistenza.
Allarme 9
Eseguire procedura di inizializzazione.
Allarme 10
Contattare servizio assistenza.
Allarme 11
Contattare servizio assistenza.
Allarme 12
Pull & Go non funziona
dopo il reset
Attendere 10 secondi dopo la conclusione
del riallineamento.
Sensori non attivano la porta
dopo il reset
Attendere 10 secondi dopo la conclusione
del riallineamento.
La porta perde l’accoppiamento magnetico
in finecorsa durante l’apprendimento
È una cosa normale, durante il funzionamento
non dovrebbero esserci problemi.
La porta apre velocemente e sbatte
a finecorsa
Rifare l’allineamento o chiamare l’assistenza
La porta apre normalmente ma dopo tre
aperture si richiude a velocità ridotta,
e alla quarta segnala allarme impatto
Assicurarsi che non ci siano ostacoli nel vano passaggio.
Eventualmente pulire la riga ottica o chiamare l’assistenza.
.
Durante il movimento della porta l’attuatore
produce un rumore anomalo di sfregamento
Smontare l’attuatore dalla porta e rimuovere con uno straccio
la polvere ed eventuali detriti sia dal binario che dal rotore.
Allarme 1
Eseguire procedura di reset e se necessario procedura di
inizializzazione.
Allarme 3
Allarme 5
Eseguire procedura di inizializzazione.
PROBLEMA
RIMEDIO
5.4
PROBLEMI E LORO RIMEDI
Eseguire procedura di reset e se necessario procedura di
inizializzazione.
Allarme 4
Eseguire procedura di reset.
Attendere raffreddamento scheda ed eseguire procedura di
inizializzazione.
Allarme 6
Allarme 7
Eseguire procedura di reset e se necessario pulire la guida
serigrafata del binario con un panno umido.
Allarme 8
Eseguire procedura di inizializzazione.
16
ISTRUZIONI PER L’INSTALLAZIONE E L’USO
M1
IT
Summary of Contents for M1
