4
Attach main Halyard to the end of the boom.
TIP:
You can tie a stopper knot in Halyard by the mast to support the boom
while you rig).
11
Finally you can thread the mainsheet as follows:
•
Starting from the centre cleat, round the ratchet (remember to check it
clicks when the rope is pulled in).
•
Through the rear block on the centre hoop.
•
Up to the rear block on the boom, going from back to the front.
•
Then down to the other block on the centre hoop.
•
and up to front block, going front to back then back down to the front
block, and through the hole in the centre.
•
Then tie off with a figure.
