36
Troubleshooting
PROBLEM
REASON
SOLUTION
System will not make water.
•
Not enough feed water pressure.
•
Feed valves are closed.
•
Tubing may be connected to wrong
port.
•
House regulator may need to be increased or
add a pump.
•
Feed water adapter, Emergency shut
-
off valve,
Angle stops.
•
See Page 12 connection.
System has a trickle of water from
faucet and has never initiated to a
high flow volume.
•
Leak down line of FA Ports.
•
System has added outlets with no
isolation valves, causing trapped air.
•
Exceeding storage capacity. Current
storage insufficient.
•
Locate leaks and repair.
•
Isolation valve needs to be added as de-
scribed in Section 2, Pages 15
-
21, and follow
procedure.
•
Revisit
“
When more water is needed
”,
Sec-
tion 3, Page 22
Water dispensing does not meet
average flows.
•
Not enough water pressure.
•
Pre
-
filter is plugged.
•
House regulator may need to be increased or
add a pump.
•
Change filter. See Page 30
Failure to dispense water from a
remote location such as a spare
RO faucet, refrigerator water dis-
penser or cooler.
•
If RO water is dispensing from the
primary faucet, then either the isola-
tion valve to the remote location is
closed or there is some tubing ob-
struction.
•
A combination of long distance from the
WOW RO
system and inadequate tubing size
may prevent the control module from acti-
vating. Limit ¼
”
tubing to runs of
15’
and use
⅜
”
tubing up to
50’.
For even longer runs
consider ½
”
tubing.
System making noise.
•
Trapped air.
•
Close isolation valves and wait until system is
full and shut down. Purge lines until steady
stream and close valve at the end. See Step 5,
Page 13.
Summary of Contents for WOW RO System
