Topray Solar crystalline solar modules should be installed by quali
Į
ed professionals only. The process involves electricity
and can be dangerous if the installing personnel are not familiar with the appropriate safety procedures.
Topray Solar crystalline solar modules are quali
Į
ed for
class A: Hazardous voltage (IEC 61730: higher than 50V
DC; EN 61730: higher than 120V), hazardous power applications (higher than 240W) where general contact access is
an
pated (Modules quali
ĮĞĚ
for safety through EN IEC 61730-1 and -2 within this application class are considered to
meet the requirements for Safety Class II).
Several modules are connected in series and then in parallel to form a PV array, especially for app
ons with a high
ope
voltage. Do not use modules of
Ěŝī
erent con
Į
gur
ns in the same system. If modules are connected in series,
the total voltage is equal to the sum of individual voltages. For
ons requiring high currents, several photovoltaic
modules can be connected in parallel; the total current is equal to the sum of individual currents.
The maximum number of modules connected in series = Vmax system / Voc at STC. When designing the PV system, please
always take into conside
the
n of the voltage under di
ī
erent temperatures (please check the
temperature coe
ĸ
cients of the modules, the Voc of the modules will be rise when the temperature drops).
Topray Solar crystalline solar modules electrical
are measured under Standard Test Condi ons (STC, irradiance of
1000W/m
2
, AM 1.5 spectrum, cell temperature 25°C /77°F). Under normal outdoor cond
, a module may produce
more current or voltage than its STC rated power. Accordingly, during system design, Short-Circuit Current and Open-
Circuit Voltage should be mu plied by a factor of 1.25 to determine component voltage
conductor ampacity, fuse
r
ng and the size of the controls connected to the modules or system output.
Tables 4, 5, 6, 7, 8, below are the major electrical chara
of Topray Solar crystalline solar modules at STC appear on
each module label. The electrical characteristics are within ±10 percent of the indicated values of Isc, Voc, Imp, and Vmp.
Maximum Power Voltage - Vmp (V)
35.60
36.00
36.40
Maximum Power Current - Imp (A)
5.20
5.28
5.36
Open Circuit Voltage - Voc (V)
44.60
44.90
45.20
Short Circuit Current - Isc (A)
5.61
5.65
5.71
Maximum Power - Pmax (W)
185
190
195
Maximum Series Fuse (A)
10
Max-System Voltage (VDC)
1000
Dimensions (mm)
1581*809*35
Weight (kg)
13
11
37.00
5.41
45.40
5.68
200
Summary of Contents for TPSM5U
Page 1: ......