Page 37
Step 2:
Install the CF card
Step 3:
Set the jumper settings
Step 4:
Install HDD
Step 5:
Install the SO-DIMM memory module
Step 6:
Mount the flat panel PC
Step 7:
Connect peripheral devices to the bottom panel of the flat panel PC
Step 8:
Configure the system
Step 0:
3.4 Unpacking
To unpack the flat panel PC, follow the steps below:
WARNING!
The front side LCD screen has a protective plastic cover stuck to the
screen. Only remove the plastic cover after the flat panel PC has been
properly installed. This ensures the screen is protected during the
installation process.
Step 1:
Use box cutters, a knife or a sharp pair of scissors that seals the top side of the
external (second) box.
Step 2:
Open the external (second) box.
Step 3:
Use box cutters, a knife or a sharp pair of scissors that seals the top side of the
internal (first) box.
Step 4:
Lift the monitor out of the boxes.
Step 5:
Remove both polystyrene ends, one from each side.
Step 6:
Pull the plastic cover off the flat panel PC.
Summary of Contents for EX-93821
