EX-93821/EX-93823 Flat Panel PC
Page 60
4.1 Gasket Replacement
A gasket used for a long time may gradually lose its ability to protect the monitor from
fluids and vapors; scratches or dirt may also accumulate. It is recommended that the
gasket be replaced yearly.
NOTE:
If the monitor is mounted vertically, first remove it and place it on a flat, level
surface with the display screen facing down before changing the gasket.
Step 1:
Remove the old gasket from the sides of the monitor.
Step 2:
Attach the new gasket to the monitor. Make sure the gasket fits precisely into the
groove along the edges of the monitor’s front panel (
Figure 4-1
).
Figure 4-1: Gasket Replacement
NOTE:
Compliance with the IP 65 standard depends on correct installation of the
gasket. Be sure to check that the gasket is properly installed after changing it.
Summary of Contents for EX-93821
