EX-96085 User Manual
27
To clear CMOS data, user must power-off the computer and set the jumper to “Clear CMOS” as
illustrated above. After five to six seconds, set the jumper back to “Normal” and power-on the
computer.
3.13 RESET / NMI SELECTION
JP4 :
Reset/NMI/Clear Watchdog Selection The selections are as follows:
FUNCTION
JUMPER SETTING
JUMPER
ILLUSTRATION
Reset (default)
3-4
NMI
5-6
User may select to use the Reset or NMI watchdog. NMI, also known as Non-Maskable Interrupt, is
used for serious conditions that demand the processor’s immediate attention, it cannot be ignored by
the system unless it is shut off specifically. To clear NMI command, user should short the “Clear
Watchdog” pin via push button.
3.14 CPU_VCCA VOLTAGE SELECTION
JP5
: CPU_VCCA Voltage Selection The selections are as follows :
SELECTION
JUMPER SETTING
(Pin Closed)
JUMPER
ILLUSTRATION
VCCA 1.8V
1-2
VCCA 1.5V
1-3
*** Manufacturing Default: VCCA 1.8V.
