www.toptechone.com
- 8 -
Observe the safety precautions to prevent skin burns.
Ignoring heat, spatter, and
sparks during operation could cause a fire or burned skin.
1.Do not perform cutting near flammables. (Move flammables well away from the
sparks.)
2.Do not cut containers filled with flammables.
3.Do not keep lighters, matches, and other flammables nearby.
4.Flames from the torch will burn the skin. Keep your body away from the torch
and tip, and check the safety before operating the switches and valves.
5. Wear the correct protectors to protect your eyes and body.
6. Correctly tighten the tip to prevent backfire.
7. When fixing a tip to the torch, tighten the nut with the two wrenches attached.
8. If the tip is tightened excessively, it will be heated during cutting and tightened
still more, making it difficult to remove the tip.
9. Avoid damaging the taper of the tip since this may cause backfire.
10. Check with soapsuds for any leakage of gas from the connection part of the
distributor, hose and torch.
11. Be sure to check the following when igniting:
Install the torch on the torch holder before ignition.
Always wear the required protectors (gauntlets, helmet, goggles, etc.)
Check for any obstacles, dangerous materials and flammables near or in
the direction of cutting. Determine the gas pressure.
The gas pressure must be within the appropriate range. (For the gas
pressure, refer to the Cutting Data.)
12. The torch, tip and heat shield are heated to a very high temperature. Always
wear gauntlets when handling them. Also the surface after cutting is very hot
so do not touch it even while wearing gauntlets.
13. Do not move the machine when the preheat flame is on.
2. Brief Introduction to Cutting Machine:
This cutting machine is a modern cutting device controlled by digital program.
