www.toptechone.com
- 17 -
The standard machine of this model is a flame cutting machine. If the customer
selects plasma cutting, plasma devices shall be added. Addition method: disassemble
solenoid valve, distributor, rubber hose, flame cutting torch and flame support and add
plasma initial positioning fixture unit. Switch the master control system to plasma
cutting model. (Use plasma motor-driven ascend/descend control line to replace
solenoid valve control line and motor-driven ascend/descend control line.)
3.5. Addition of Flame Cutting Function in Plasma Devices
If the customer selects plasma cutting, flame devices shall be added. Addition method:
install solenoid valve, distributor, rubber hose, flame cutting torch and flame support
and remove plasma fixture unit. Switch the master control system to plasma cutting
model, and use the spanner to tighten the connecting lock nut. Carry out pressure test
through ventilation and use soap water to wipe the connection to check if it is gas
leaking. (Replace plasma motor-driven ascend/descend control line with solenoid
valve control line and motor-driven ascend/descend control line.)
3.6. Gas Supply of Relevant Devices
The device gas inlet interface is the Ф8mm gas-type fitting according to the national
standard. The user may decide the length of gas supply pipe according to the distance
between gas source and device and the cutting stroke. Please use the minimum
pipeline length, thus avoiding the reduction of gas flow. The user must add an about
200-mesh gas filter at the gas supply interface to assure clean gas source and prevent
the impurities in the pipeline from damaging the solenoid valve and blocking the
cutting pipeline.
3.7. Addition of Second Flame Gun (upon customer’s demand)
3.8. Addition of Cutting Platform (upon customer’s demand)
3.9. Control Profile
