www.toptechone.com
- 5 -
2. When mounting hoses to the torch and distributor, tighten the nut with the
attached wrench. After mounting, be sure to check there is no gas leak with a
detection liquid. If a gas leak is found, retighten the nut firmly.
3. When fixing a tip to the torch, tighten the nut with the two wrenches attached. In
addition, avoid damaging the taper part of the tip since this may cause backfire.
4. Never disassemble the machine other than during maintenance and inspection.
Otherwise, malfunction will result.
5. Never remodel the machine. Remodeling is very dangerous.
6. When changing the travel direction, make sure that the direction switch is in the
neutral (stop) position, and operate the direction switch after the machine has
stopped.
7. Always turn the power off when not used.
8. Never use the machine outdoors when the weather is wet. This will cause
failure of the machine and could cause a fatal accident by electric shock.
1.1.2 Safety clothing
1. Be sure to wear protector's gauntlets, goggles, helmet, and
safety shoes during operation.
2. Avoid operating the machine with wet clothes or hands in order
to prevent electric shock.
1.1.3 Operation and handling safety precautions
1. Read this instruction manual before operating the machine.
2. Mount and center the machine correctly and confirm correct motion before
operation.
3. Prior to connecting the power plug with the socket, make sure the power
switch in OFF position (turn the switch clockwise or counterclockwise to the
stop position).
4. Prior to operating the machine, check the safety of the surroundings to avoid
accidents.
5. Never move the machine while the preheat flame is on.
6. When an operation is carried out at a higher position, be careful that the
splashes and slugs may hurt others at lower position.
7. Be sure that the clutch is in state of meshing before operation, any
improper state may cause accidents.
8. Be careful that the hands may be caught in erecting guide rail.
9. When cutting along the guide rail, be sure to fix the small guide roller
properly.
10. Erect the preheat board properly to avoid affection to the guide rail.
11. To avoid that holder of torch from falling, use the bolt on the sliding
holder to fix it.
12. Be sure to hold tight of handles in moving the equipment.
