TK218 OBD-II GPS Tracker
User Manual
Page 6
then use the mobile 13780012345 to call the tracker, it will be connected automatically, and
user can monitor the voice around.
SMS command:
111111MON:P1*P2*P3*
This instruction is used to program the phone number which is used for
carrying out direct monitoring.
Once set up, any call from P1 or P2 or P3 will be picked up automatically by
the tracker. By this way, user can monitor the voice conveniently.
Example: 111111MON:13922713571*
Note: If the phone is the same as the first alarm-received phone (111111*10
Mobile #1*20 Mobile #2*), the calling from this telephone can only arm/disarm
the tracker.
Check the Real Physical Address
SMS command:
111111ADD
(or
111111add
)
User can program the tracker to work with our platform. Once connected, user can
send this SMS command to get the actual address which is translated by the platform..
Remark: (1) The GPRS data service of the tracker’s SIM card must be activated, and
the correct GPRS setting is needed (refer to the chapter of the setting of GPRS
connection); (2) The physical address depends on the map of the platform..
Change User Password
SMS command:
111111PSWnnnnnn
(or
111111pswnnnnnn
)
This instruction is used to change the user password. The length of the
user’s password is 3~6 digits. Users are suggested to change to the new
password in use.
Example: User sends the SMS “111111PSW12345” to the system SIM card
number, and gets the confirmed SMS “111111PSW12345” in 3 seconds. It
means that the user password has been changed to 12345.
Remark: Please keep the password deep in mind if it is changed.
Over-speed Alert
111111SPD:X
x is the speed in KM/H , maximum value is 255KM/H
(For example: 111111SPD:120, if the car speed is over 120KM/H, it will
