TK218 OBD-II GPS Tracker
User Manual
Page 7
send alert SMS to warn you).
111111SPD:0
to disable the over-speed alert. It is the default setting.
111111SPD:
to check the setting of over-speed alert.
when the car speed is higher than the speed value, it will trigger the
over-speed alarm.
Remark: this function is just for reference, because there might be some
time delay or error in detecting the running car’s real speed by GPS.
Power Save Mode
SMS command:
111111PWR:X
Value of X
Actions
0 (default)
Disable power save mode
1
Close GPRS connection
2
Close GPRS connection,GPS module
After setting 111111PWR:1(or 2), if there is no vibration and ACC is turned
OFF, the tracker will go into power save mode after 2 minutes.
Once there is vibration or engine is turned ON, or incoming call/SMS, the
tracker will wake up from the power save mode immediately.
Switch CAN-Bus Protocol
111111CAR:X
(X=0 or 1)
111111CAR:0 : it uses the protocol for general cars (default)
111111CAR:1 : it uses the protocol for big truck (SAE J1939 & ISO 27145)
Other SMS Command List
Note: ****** is user’s password and the default password is 111111. The
tracker will only accept commands with the correct password.
Functions
SMS Command
Example
Auto Report by SMS
******RPT:X
111111RPT:5
