TK220 GPS Car Alarm Website:www.t10.cn, email:sales@t10.cn User Manual
Page
8
Set up the Shock Sensor
Command
:
111111SHK@
Normal status, when shock sensor is activated, it will trigger the alarm
immediately.
@=0, turn off shake sensor.
@=1, normal working mode(default setting).
Normal status, when sensor is activated, it will trigger the alarm immediately.
It is the default setting
@=2, Time-delay working mode
Time-delay status, if the sensor is activated for 3 seconds continuously, it
will trigger the alarm. This setting can avoid some false vibration alarm.
Arm the System Mutely.
There are two ways to carry out the function.
(1)
Command
:
111111MUTE:0
, to turn off mute alarm.(default setting)
111111MUTE:1
, to turn on mute alarm.
when user turn on MUTE alarm function, the vibration sensor will not
trigger the siren & it will not send out alarm SMS, but if the door is open
or ignition is ON, it will trigger alarm normally.
(2) Remote controller
You can press mute button to carry out this function too.
Turn ON/OFF Sleep Mode.
111111SLEEP0
Turn off sleep mode, it is the default setting
111111SLEEP1
Turn ON sleep mode, it is used to save power & GPRS
flow. In this working mode, if the engine is OFF, the system will go into sleep
mode after 3 minutes. In sleep mode, the device only reports the heart-beating
packet by GPRS, GSM & GPS module will go into power save mode also. Once
there is any vibration, or alarm, or incoming call/SMS, the system will wake up
immediately.
