Shanghai TopXGun Robotics Co.,Ltd.
6th Floor,3rd. Building,Elite City,No. 57, AnDemen Street,Yuhua District,Nanjing,China,210012
TEL:
025-86467760
FAX:
025-52323411
5-8 channel switch to the maximum limit position and minimum limit position of
each channel several times, then click
“
Complete Calibration
”
.
Unlocking is only possible if the remote controller is properly calibrated.
Please check whether the forward and reverse directions of each channel are
correct:
l
The aileron goes right, rolling the slider to the right
l
The rudder goes right, yaw slider goes right
l
The elevator goes down and the pitch slider goes right
l
Throttle lever goes up, throttle slider goes right
If the directions are not consistent, click "REV" to set the reverse direction.
4. Switch 5~8 channel switches. Check whether the stop position corresponds to the
control mode one by one and whether the return flight map is normal.
If the receiver is not an SBus receiver, the remote controller must be set to
runaway protection. When the setting is successful, if the remote controller is
turned off, 1~4 channels maintain the neutral point position. 5 channels jump
to the red "runaway" area, no need to set other channels. Please refer to the
remote controller manual for specific operation.
Figure 2-5 Remote Control Settings
