Shanghai TopXGun Robotics Co.,Ltd.
6th Floor,3rd. Building,Elite City,No. 57, AnDemen Street,Yuhua District,Nanjing,China,210012
TEL:
025-86467760
FAX:
025-52323411
If the power and flight controller are powered separately, you need to cut
off the power first before applying the power to the electric speed
controller calibration again, then disconnect the flight control power and
finally connect the power after powering the flight controller on .
Step 4. After the power is turned on about 0.5 second, you will hear
“
beap-beap
”
from motor two times and then pull the throttle to the lowest level in 2
seconds. At this time, the state indicator red lights and blue lights are
flickering alternately and then get into normal indication.
Operation chart is shown in the fig.2-13.
Fig.2-13 Electric speed controller calibration
图
2-13
电调校准
After ESC is calibrated successfully, the motor will rotate in sequence when it is
unlocked, otherwise recalibration is required. Because DJI series ESC idle speed is
higher, when you apply the recommended idle speed to unlock the motor, there will
be phenomenon without idling speed
Compass calibration
Operating steps of compass calibration as following :
Step 1. Push throttle to the lowest level
Step 2. Switch 5-channel button back and forth between the lowest level and highest
level about 6-10 times until the red light and blue light of the state indicator are in
long brightness.
Step 3. Forward the head of the flight and lay it on the horizontal position, then
slowly rotate clockwise at least one full turn until the green light of the state
indicators is on long brightness.
