Shanghai TopXGun Robotics Co.,Ltd.
6th Floor,3rd. Building,Elite City,No. 57, AnDemen Street,Yuhua District,Nanjing,China,210012
TEL:
025-86467760
FAX:
025-52323411
Step 1. Switch the 5-channel flight mode button back and forth and observe
whether LED lamp of the flight mode indication is consistent with the position of
the mode switch.
Low altitude test flight
Step 1. Keep the aircraft at least 5 meters away from the operator and wait for
the flight control system to search the satellite normally (the red flash light turns
to the green flash light).
Step 2. Push the remote controller lever to the lower right corner under the
gesture mode, the motor is unlocked, and starts up in turn from motor 1; If the
throttle lever exceeds 20% during the course of start-up in turn, all motors will
start-up immediately.
Step 3. After the motor is fully started, slightly push the throttle lever to be held at
about 30% with slightly rolling and pitching rod, observing whether the
acceleration trend of the motor is the same as the lever, if so, rolling and pitching
rod return to the middle, then continue to push the throttle until the aircraft is off
the ground.
Step 4. Feel the handling of each control channel below 2 meters height, if the
response is normal, you can continue to tap the maximum potential of flight
controller.
After flight, you must check that if the temperature of the forward motor
and the reverse motor are the same. If the temperature is not consistent,
the aircraft may have the phenomenon of load imbalance, the propeller
plane needs to be calibrated to ensure that the propeller plane is consistent.
4 Functional description
4.1 Out of control return
If you use an SBus receiver, you do not need to set out of control protection
separately; if you use a PWM or PPM receiver, you need to set 5-channel as an
out-of-control protection area (check that if it is set as the out-of-control protection
area by turning off the remote control). See "step 4" in
“
the installation Test steps
”
.
After the remote control signal is lost, the LED indicator changes to {
} (
∞
)
first, After hovering for 5 seconds, the aircraft will return to over the take-off point
and land,locked. If the remote control signal recovers during this process, the aircraft
will continue to perform automatically return; to interrupt the return action, the
remote control 5-channel must be switched at least one time.