4.
To select or change a unit of measure press the Unit / Clear button until a desired unit of measure is highlighted.
5.
Before taking a measurement zero the force gauge by pressing the
0
/ ENTER key.
6.
To measure the compression force (push)
of an object, align the force gauge shaft to
the object measured. If measuring by hand
grasp the device firmly. Push the force
gauge forward with the attached tip
pressing into the object. Observe the
measurements recorded as the force is
applied.
7.
To measure the tension force (pull) of an
object, align the force gauge shaft to the
object measured.
If measuring by hand grasp
the device firmly.
Wrap the hook tip around
the object and pull the force gauge away from
the object.
Observe the measurements being
recorded as the force is applied.
8.
Depending on the configuration and mode in use, measurements are
captured automatically or with a press of the START key.
STANDARD
MAN
AUT SDM
0.00 N
- +
STANDARD
MAN
AUT SDM
0.00 N
- +
ZEROING
_ _ _ _ _ _
_ _ _ _ _ _
[N]
[kgf]
[lbf] [ozf] [kg] [lb] [oz]
[N]
[kgf]
[lbf] [ozf] [kg] [lb] [oz]
