- 19 -
5.
To configure the scale’s display during check counting use the navigation keys to select
“Display
Setup”
and press the ENTER key. To disable information from displaying during the function use the
navigation keys to highlight the desired selection and press the ENTER key to remove the check mark.
Once the check mark has been removed the information will not display while performing check
counting.
6.
To exit Check Counting set up use the navigation keys to select
“Exit”
and press ENTER.
8.1.4.
Percent Weighing
1.
To configure the Percent Weighing Function, use the navigation keys to select
“Percent Weighing”
in
“Mode Setup”
and press ENTER. The status and available Percent Weighing options will be
displayed. If the function is currently in use the status will be set to
“ON”.
2.
To select an operating mode use the navigation keys to select
“Mode”
and press ENTER. By default
Percent Weighing is set to
“Auto”
(Automatic). To operate Percent Weighing in manual use the
navigation keys to select
“Manual”
and press ENTER.
