- 23 -
5.
To assign a
“Quick Key”
use the navigation keys to select
“Quick Key”
and press the ENTER key.
Use the navigation keys to select a desired quick key (F1 through F5). Once the desired key is selected
press the ENTER key to accept the selection.
If the key is not available (used by a different function) a warning message will be displayed
“Warning Quick Key Already In Use!”
To override the key press ENTER. To abort and select a
different function key press the CLR key.
6.
To configure the scale’s display during compounding use the navigation keys to select
“Display
Setup”
and press the ENTER key. To disable information from displaying during the function use the
navigation keys to highlight the desired selection and press the ENTER key to remove the check mark.
Once the check mark has been removed the information will not display while performing
compounding.
7.
To exit Compounding set-up use the navigation keys to select
“Exit”
and press ENTER.
8.1.7.
Check Weighing
1.
To configure the Check Weighing Function, use the navigation keys to select
“Check Weighing”
in
“Mode Setup”
and press ENTER. The status and available Check Weighing options will be displayed.
If the function is currently in use the status will be set to
“ON”.
