- 28 -
3.
To assign a
“Quick Key”
use the navigation keys to select “Quick Key” and press the ENTER key.
Use the navigation keys to select a desired quick key (F1 through F5). Once the desired key is selected
press the ENTER key to accept the selection.
If the key is not available (used by a different function) a warning message will be displayed
“Warning Quick Key Already In Use!”
To override the key press ENTER. To abort and select a
different function key press the CLR key.
4.
To configure the scale’s display during display hold use the navigation keys to select
“Display Setup”
and press the ENTER key. To disable information from displaying during the function use the
navigation keys to highlight the desired selection and press the ENTER key to remove the check mark.
Once the check mark has been removed the information will not display while performing display
hold.
5.
To exit Display Hold set-up use the navigation keys to select
“Exit”
and press ENTER.
8.1.10.
SQC Process Control
1.
To configure the SQC Process Control Function, use the navigation keys to select
“SQC Process
Control”
in
“Mode Setup”
and press ENTER. The status and available check weighing options will be
displayed. If the function is currently in use the status will be set to
“ON”.
