9
Locate the fin and rudder assembly and test fit in
the fin slot.
Apply adhesive into the fin slot and insert the fin.
Check that the fin is vertical and square to the
fuselage and tail plane and adjust if necessary.
Use a damp cloth to wipe off excess adhesive and
allow to dry
Slide the nose wheel in place and screw the
retaining cap onto the wire to secure.
Apply the self adhesive decals to the top surface of
the wing as shown.
The rear of the decal lines up with the trailing edge
and aileron cut out.
Locate the wing assembly and position it near the
wing seating area .
Take the plug on the aileron servo lead and push
plug into channel no 1 of the receiver.
Switch on the transmitter and centre the servo
trims.
Temporarily connect the battery and ESC leads
together and check that aileron servo arm is
central. Adjust if necessary and secure with screw.
Disconnect battery.
Summary of Contents for TB-20
Page 1: ......
